fbulk 'Can't Write Target Memory'

General problems? Ask here!

Moderator: cbarnes

fbulk 'Can't Write Target Memory'

Postby PaulPounds » Tue Apr 17, 2007 12:02 am

Hi all,

I'm using an Adapt912DP256 with pod to program some custom HC12D60 boards. I've recently run into a problem where, when I try to fbulk the micro, I get a 'Can't Write Target Memory' error. I get the same message when when I fload.

This occurs on all four boards I've tried with the programmer, uploading different programs, which makes me suspect the programmer is at fault rather than the boards. I've tried reloading the programmer firmware with no change in behaviour.

Any ideas on why this error might be occuring or how to fix it?

cheers,

-Paul
PaulPounds
Intermediate
 
Posts: 25
Joined: Thu Apr 28, 2005 10:25 pm
Location: Canberra

Return to General Problems

Who is online

Users browsing this forum: No registered users and 3 guests

cron